Material Safety Data Sheet

Shield Industries, Inc. - 131 Smokehill Lane - Woodstock, GA 30007

Day Telephone (770) 517-6869

Emergency Telephone 1 (800) 535-5053

MSDS Page 1

ForceField® UV SunBlock

 

Section I Product Identification

Product ID: F UVSB

Last Revision Date: 10/26/00

Preparer: R. Lasnik, Vice President

 

Section II Hazardous Ingredients

Synthetic Isoparaffinic Hydrocarbon (Combustible Liquid)(CAS 64742-48-9), 35-75%

1-Methoxy-2-Propanol (CAS 107-98-2), 2-4%

Triazine UV Absorber, (No CAS# Assigned), 21-67%

HMIS Rating: Health-1 Flammability-2 Reactivity-0 PPE-X

 

Section III Physical Data

Boiling Point: >300 Fahrenheit

Water Solubility: Insoluble

Specific Gravity: 0.80           Weight Per Gallon: 6.67 lbs.

Odor: Mild Petroleum

Appearance: Clear Light Yelow Liquid

 

Section IV Fire and Explosion Hazard Data

OSHA: Combustible Liquid

Flash Point: 104 0F

Extinguishing Media: Dry Chemical, Carbon Dioxide, Water Spray, Dry Chemical,and Foam

Special Fire Fighting Procedures: Evacuate personnel to a safe area upwind of the fire. Avoid breathing decomposition products. Respiratory protection is recommended for fire fighting personnel. Water fog nozzles may be used to cool fire-exposed containers.

 

Section V Health Hazard Data

Primary Route(s) of Entry:      Inhalation: Y      Ingestion: Y      Skin: Y      Eyes: Y

Effects of Acute Overexposure:

Eye: May cause stinging of eyes followed by irritation.

Skin: Prolonged and repeated skin exposure may be irritating to some people.

Ingestion: May be harmful or fatal if ingested. Seek medical attention immediately.

Inhalation: Over exposure can cause irritation to mucous membranes. Vapor concentrations greater than 1000 ppm may cause headaches and dizziness, and are anesthetic.

Section V Health Hazard Data (Continued)

Carcinogenicity Information: IARC, NTP, OSHA or ACGIH lists none of the components present in this material as a carcinogen.

First Aid Procedures: 

Inhalation: Remove to fresh air. If not breathing give artificial respiration.

If breathing is difficult, give oxygen and call a physician.

Skin Contact: Flush skin with soap and water. Wash contaminated clothing before reuse.

Eye Contact: Flush eyes at least 15 minutes with fresh water. Call a physician if irritation persists.

Ingestion: Do not induce vomiting. Keep at rest and seek medical attention immediately.

 

Section VI Reactivity Data

Instability: Stable

Incompatible Materials: Avoid strong oxidizing agents and water.

Hazardous Decomposition Products: When heated above 392 Fahrenheit, or under fire conditions, may form toxic decomposition products. These products may cause severe eye, nose, throat, and lung irritation. Use adequate ventilation.

Hazardous Polymerization: None will occur.

 

Section VII Spill or Leak Procedures

Spill, Leak, or Release: Eliminate all ignition sources. Contain spill and salvage as much material as possible. Pick up the remaining with absorbent.

 

Waste Disposal: Dispose of only by methods approved by and used in accordance with local, state, and federal regulations.

 

Section VIII Special Protection Information

Respiratory: Use only with adequate ventilation. Vent fumes outside work area. When applying as a spray, use exhaust ducts, fans, and other features to minimize exposure to mists, vapors, and over-spray. Recommended exposure limit is 300 ppm for an 8 hour day, at greater levels use a NIOSH/MSHA approved respirator.

Protective Clothing: Where skin contact is likely, have available and wear as appropriate impervious gloves, apron, pants and jacket to prevent prolonged contact.

Eye: Use safety eye wear or chemical splas goggles.

 

Section IX Special Precautions

Avoid contact with eyes, skin, and clothing. Wash thoroughly after handling. Do not aerosolize. Always provide adequate ventilation. Use only in low-pressure sprayers (less than 60 psi). Store in a well ventilated place at a temperature above 45 and under 120 Fahrenheit. Keep away from open flames, heat, sparks, pilot lights, static electricity, and heated surfaces. Use proper grounding techniques. Keep container tightly closed to prevent leakage or evaporation. Keep out of reach of children. Dispose of empty containers with care, product residues may ignite. Do not pressurize, cut, weld, braze, solder, drill, grind, or expose containers to sources of heat or ignition.

 

Section X Regulatory Information

EPA Regulations: SARA Section 311/312 Hazards Categories: None

DOT Shipping Name: Not Regulated in quantities less than 119 gallons.

TSCA Inventory Status: Mixture

 

Disclaimer: As the handling and use of products under user’s conditions are beyond our control, no warranty, expressed or implied, including, but not limited to merchantability or fitness for a particular use, is made concerning this product. The user assumes all risk of use or handling whether or not in accordance with any directions or suggestions of the supplier. Seller shall not be liable to purchaser or any other person for loss or damages directly or indirectly arising from the use of our products, from breach of any warranty or from any other cause, the exclusive remedy against the seller being to require replacement or repair of defective goods.

 

Back To Product

Emergency Telephone 1 (800) 535-5053